How to make paracord bracelet. - Crafts DIY jewelry

Table of Contents

How to make paracord bracelet chained. Instructions for paracord bracelets. Paracord bracelets step by step tutorial.

Today I will tell you how to weave a two-color bracelet chained made of paracord 550. I myself do not wear paracord bracelets, but I love to weave them and give them to friends and acquaintances. I especially love the process of working with the paracord. I also like taking pictures and videos and sharing them with you.

To make a paracord bracelet, we will need:

Paracord 550 yellow, approximately 1.7 m
Paracord 550 brown, approximately 1 m
Plastic clasp 15x30mm
Gas lighter
Scissors

Instructions for paracord bracelets.

Take the yellow paracord, and fold it in half. Slip the loop from above into the hole of the plastic clasp. Slide the ends of the paracord through the loop. Slide the brown paracord between the paracord. Right and left parts of the paracord should be the same length.

Tighten the knot. Bring the brown paracord behind the yellow paracord on the left and right.

Bring both ends of the yellow paracord as shown in the photo below.

Gently tighten the knot.

Next, put the brown paracord behind the yellow one once again.

Place the yellow paracord not like last time, but a little differently. See the photo below.

Tighten the knot. Thus, we made the first part of the chain.

Then repeat the knots in turn – first the first knot, then the second one, and so on. This is the main secret on how to make paracord bracelet.

Weave a chain and make a bracelet of the desired size. Do not forget to take into account the size of the clasp. My bracelet is 20 cm long, not considering the clasp.

Unfasten the clasp and slip the two ends of the yellow paracord into the free section from above.

Make a knot out of yellow paracord.

Tighten the knot firmly. The photo below shows the back side of the bracelet. And the main part of the tutorial on how to make paracord bracelet is over

How to melt the ends of the paracord.

If you want to know jow to make paracord bracelet stick with me for a while – there’s just a little bit left. We need to melt the tips of the paracord so that it doesn’t unravel. We will need scissors and a lighter. First, cut off one end of the paracord so that you have a tip of about 5 mm left. Bring the fire of the lighter to the paracord. The paracord should not catch fire, it should only melt. As soon as the paracord melts, press the paracord with scissors. It should look like a nail head. After such a procedure the paracord will not unravel.
Process all the ends of the paracord in the same way.

Nothing will happen if your paracord catches fire while melting. Blow on the flame to make it go out and press the paracord down. If the paracord catches fire, the “hat” will be a little dirty and soiled. If you are new to weaving, that’s okay. You will learn everything over time.